Scorpion HK-4015 Shaft Kit (5mm)
The Scorpion HK-4015 motors are built with 8mm hardened steel shafts that will last through countless hours of flying fun, but occasionally, on a "Less than Perfect" landing, you may bend or break one. For these occasions, we offer factory replacement shafts for all the HK-4015 series Scorpion Helicopter Motors.
The shaft for the HK-4015 series motors measures 6mm in diameter, and is 73.7mm in long. The Stock HK-4015 motors have a 5mm output shaft end on them to allow the user to install 5mm pinion gears. The shaft kit will also fit other brushless motors that require an 6mm shaft of this length with a 5mm end. The shafts can be cut shorter with a Dremel tool and a cut-off wheel if necessary to fit other motors.
Note: The shafts in the Scorpion motors are a slight press fit into the aluminum front housing. The shafts will not just slide out when the setscrews are removed. They need to be pressed out in a bearing press, or in a drill press, with the front housing of the motor supported in a block of wood to prevent warping the front housing.
Included in the Box- HK4015 Motor Shaft (5mm) x1
- Washer x 1
- C-Clip x 2