|
●Suitable for ALIGN M6T22/M4/M6/E1 PLUS Agricultural Drone.
●These high discharge lithium polymer batteries are designed to maintain performance in series configuration, and can be charged individually through balancing plug. The extreme high capacity are catered specifically for applications requiring longest flight duration.
●Max Continuous Discharge: 35C. Normal operating temperature is approx. 40-65°C(within 80% of rated discharge). Max. temperature: 80°C.
●Recommend to discharge the battery within 80% of rated discharge, keep 90% capacity when over 100 cycles, keep 85% capacity when over 150 cycles.(The cycle life and efficiency will reduce due to high current, high temperature and over-discharge)
AS150U-F New Connector
●Effectively prevent the spark while plugging in battery also reduce the damage of electronic equipment and connector plugs.
●Newly add waterproof rubber on the bottom of the connector, and the rear welding part is covered with rubber to effectively prevent the penetration and corrosion of the pesticide.
●Enlarge the diameter of the internal gold plating connector and the contact resistance can be lower than 0.2mΩ
NOTE:
When using high energy Li-poly Battery, please do not over-discharge, over-charge batteries, or result over-high temperature. Discharging capacity can’ t exceed 80% of the max capacity after full charging to ensure a good cycle performance.Recommend to full charge a brand new battery before using and only discharge the battery 50% for first 5 times to make a good efficiency of the battery. Please make it a habit to always count time for flight, or please set a low voltage protection on ESC (Cell voltage after stopping using can not lower than 3.4V). Do not use the battery at insufficient of voltage.
Do not expose batteries to sunshine or store/ charge batteries at the temperature up to 35℃ in a airtight car. The environment high temperature could cause the damage or the danger of burst. If the battery becomes hot while high current discharging or flying, please do not charge the battery immediately. Wait to cool down(about 20 mins), then inspect to recharge. If against follow the original factory using rules, possibly cause the battery to inflate or any dangerous accident happens.
Do not leave the charger is operating unattended as it may cause a fire. Charging error could result in battery explosion, fire, and other unexpected danger or property loss. Please always charge batteries with equipment in sight, do not leave charger unattended. Should you need to leave the charging area, please remove the battery and abort charging process.
|
●Output:22.2V/22000mAh 488.4Wh(6S1P)
●Support 5C charging.
●7-pin plug
●Dimension:205x92x70mm
●Weight:2730g
●Max Continuous Discharge:35C
●Using 8AWG wire,thermal resistance:200°C, max continuous current 140A.
●AS150U-F Connector
|
