SG280 - GOBLIN FIREBALL (with standard motor and blades)
EASIER THAN EVER
Simplicity is the key feature of the Goblin Fireball
The goal of the project was to design a simple model with, good performance that crashes well and is fast, simple and cheap to repair.
For fun, for training, for HARD 3D it must be the Goblin Fireball!
Registered design 003738210-0001/0004
Main rotor diameter: 626 mm
Main blade length: 280mm
Tail rotor diameter: 139 mm
Tail blade length: 50 mm
Main shaft diameter: 5 mm
Tail shaft diameter: 3 mm
Weight including electronics: 735g (excluding batteries)
Direct standard Motor included
Cyclic Servos: Micro size 23mm
Tail Servo: Micro size 23 mm
Speed Control 50-60A
Typical battery setup: 6S 1000/1250 mAh
With the new-patented "Direct Drive" system, this has been achieved.
The reduced parts count delivers maintenance that has never been easier! Carefully selected materials used in the soft plastic landing gear, plastic blade grips arms, hard steel shaft, strong plastic frames and a polycarbonate canopy and boom secure minimal crash damage and reduce repair bills.
Cheap to replace the polycarbonate canopy and boom
Easy maintenance, the rotor head can be removed with only 2 screws
Motor shaft and main shaft are connected with a mechanical joint
Plastics blade grip arms become a sacrificial part to protect other vital components. For simplicity the arms can be replaced with 1 screw
Super strong rotor head design delivers resilience in a crash
Magnetic canopy release system
Micro tail servo 23mm isze
Serial number on the main plate and on your registration card. When you register your kit you are helping us to fully support YOU the “Goblin way”.